MTP-12 to MTP-12 UPC Trunk Cable, Female, 48 Fibers, OM3, Type B

Our 48 Fibers (Base-12) MTP® Elite Female trunk is the fast way to move many fibers between two points. OM3 50/125µm performance, Plenum (OFNP) jacket, and controlled breakout geometry mean predictable loss and tidy routing in the main distribution area.

Standard lengths are 1m (3ft), 3m (10ft), 5m (16ft), 7m (23ft), 10m (33ft), 15m (49ft), 20m (66ft), 25m (82ft), 30m (98ft) and 40m (131ft). Because we are the manufacturer, any other length between or beyond these steps can be produced on request, with your choice of jacket color, labeling and packaging.

Product Highlights

• MTP® Elite Female (Non-Pinned) to MTP® Elite Female (Non-Pinned), 48 Fibers (Base-12)
• OM3 50/125µm, bend insensitive fiber
• Insertion loss ≤0.20dB, return loss ≥27dB
• Type B polarity
• 8.5-9.0mm Plenum (OFNP) round cable
• Minimum bend radius 7.5mm
• Ten standard lengths from 1m (3ft) to 40m (131ft), custom lengths built to order

Backbone cabling is where mistakes cost the most, so this trunk is built and verified entirely in the factory. The 48 Fibers (Base-12) construction concentrates the equivalent of many duplex jumpers into a single assembly, which is exactly what high density spine and leaf cabling needs. It arrives with test results, labeled legs and the correct polarity for your panel layout.

The trunk uses a double jacket design: a rugged outer sheath protects the whole bundle, while each breakout leg keeps its own jacket and numbering. Base-8 and Base-12 constructions are available depending on the fiber count. Polarity follows the Type shown in the table, and pulling eyes or mesh grips can be fitted for installation.

To order, quote 48FMTPOM3 together with the length and quantity you need. The 1m (3ft) version is the standard model; Private labeling, custom packaging and project specific documentation are all handled in-house.

We do not ship untested product. Each unit is measured on calibrated equipment for optical performance and visually inspected for end face quality before packing. Batch traceability is maintained so any field issue can be tracked back to production.

Each assembly is coiled, capped and sealed in an individual bag, then packed into foam lined export cartons. Test reports can be attached per unit or per batch, and carton marks follow your shipping instructions.

Our engineering team handles custom MPO/MTP assemblies daily. If the standard configuration does not match your link design, send us the requirement and we will build exactly what your network needs at factory-direct cost.