Customized MPO-8 to 2 x MPO-4 Breakout Cable, 8F, Type B, OM4

Use this MPO Female breakout when one high speed port needs to serve multiple devices. OM4 50/125µm fiber, 8 Fibers and Plenum (OFNP)/Dual Rated (OFNR/LSZH) jacket, fully tested on both the trunk side and every breakout leg.

Available lengths are 1m (3ft), 2m (7ft), 3m (10ft), 5m (16ft), 10m (33ft), 15m (49ft), 20m (66ft), 25m (82ft) and 30m (98ft). We can also produce any intermediate or longer length to order, with your choice of labeling and packaging.

Product Highlights

• MPO Female (Non-Pinned) to MPO Female (Non-Pinned), 8 Fibers
• OM4 50/125µm, bend insensitive fiber
• Insertion loss ≤0.35dB, return loss ≥45dB
• Type B polarity
• 3.0mm Plenum (OFNP)/Dual Rated (OFNR/LSZH) round cable
• Minimum bend radius 7.5mm
• Stock lengths from 1m (3ft) to 30m (98ft), custom lengths on request

This breakout is used wherever one multi-fiber interface must serve several devices. The 8-fiber version matches 400G and 800G parallel interfaces that run on 4 or 8 lanes, such as QSFP112, OSFP and twin-port OSFP connections. The factory controlled fan-out keeps each leg at the right length and polarity, avoiding the tangle of separate patch cords.

Each breakout leg is individually jacketed, labeled and measured, and the transition from trunk to legs is protected against pulling forces. If your installation needs different leg lengths or a different lane mapping, we can build it to your drawing.

To order, quote 8FMPOOM4 together with the length and quantity you need. Private labeling, custom packaging and project specific documentation are all handled in-house.

Our engineering team handles custom MPO/MTP assemblies daily. If the standard configuration does not match your link design, send us the requirement and we will build exactly what your network needs at factory-direct cost.

Every MPO/MTP assembly leaving our factory is 100% tested for insertion loss and return loss, with end face geometry checks on the multi-fiber ferrules. Controlled polishing keeps the loss budget stable across the whole batch, which matters when several mated pairs sit in one link.

Each assembly is coiled, capped and sealed in an individual bag, then packed into foam lined export cartons. Test reports can be attached per unit or per batch, and carton marks follow your shipping instructions.