Dell (Force10) CBL-10GSFP-AOC-2M Compatible 10G SFP+ Active Optical Cable, 2m (7ft)

The (Force10) CBL-10GSFP-AOC-2M cable offers a direct SFP+ to SFP+ connection at 10Gbps. Its 2m (7ft) length and AOC construction are intended for Dell equipment, with no separate transceiver-and-patch-cord assembly required.

OEM Part Number: (Force10) CBL-10GSFP-AOC-2MHT Part Number: (Force10) CBL-10GSFP-AOC-2M

Product Highlights

• Compatible alternative to Dell (Force10) CBL-10GSFP-AOC-2M
• 10G connectivity at 10Gbps
• Interface configuration: SFP+ to SFP+
• Fixed length and part number: 2m (7ft), (Force10) CBL-10GSFP-AOC-2M
• Cable construction: OM2/OM3
• Maximum power consumption: <0.8W
• Minimum bend radius: 30mm

The rated power consumption is <0.8W. Include this load in the host-port power and thermal budget, especially in densely populated switches. Maintain front-panel clearance and do not bundle the cable so tightly that it obstructs airflow around the connectors.

The optical engines and fiber are permanently integrated into this AOC. There are no detachable optical modules to clean or exchange. Handle the complete assembly by its connector housings and cable, and keep both ends matched to the same interface specification.

(Force10) CBL-10GSFP-AOC-2M provides 2m (7ft) for connections between separated rack units or nearby equipment positions. Plan the route around cable managers and power cords, keeping the assembly free from connector strain while avoiding a large obstruction in the airflow path.

(Force10) CBL-10GSFP-AOC-2M occupies the middle of this family between (Force10) CBL-10GSFP-AOC-1M at 1m (3ft) and (Force10) CBL-10GSFP-AOC-3M at 3m (10ft). It adds 1m over the shorter option for extra routing clearance, while the next longer version adds another 1m. Measure the managed path and choose this version when its reach is sufficient without creating the slack associated with the longer assembly.

This assembly uses OFNP jacket, minimum bend radius 30mm. These mechanical characteristics affect how the cable should be dressed behind the equipment. Avoid sharp edges, excessive ties and repeated tight bends close to the connector boots.

The intended application is determined by the host interface and protocol support. Listed interface and protocol references include SFF-8636, 1xInfiniBand QDR,DDR,SDR, 10G Gigabit Ethernet. Confirm that the host firmware and port configuration support the same operating mode.

The assembly is configured for equipment that recognizes (Force10) CBL-10GSFP-AOC-2M. Before shipment, we inspect both connectors and verify identification, link establishment and optical link operation, receive activity and diagnostic readouts. Host hardware and firmware revisions can affect third-party cable acceptance, so customers can provide the equipment model and software release for a pre-order compatibility review.

Use part number (Force10) CBL-10GSFP-AOC-2M for the 2m (7ft) assembly. For mixed-length projects, list each required part number and quantity separately so that every cable can be tested and packed according to its intended installation.

Before packing, our team checks the cable jacket, connector boots, latches and identification of each assembly. The cable is then secured in a loose coil and protected against dust and connector impact. Neutral packaging, customer part-number labels and project-specific carton lists can be supplied on request.

Lead time for ordinary configurations is normally one to three working days, while production quantities are confirmed with the order. We can arrange express courier or economy freight according to destination and carton volume, or hand the shipment to your appointed logistics provider.