MTP-12 APC to LC UPC Uniboot Trunk Cable, Female, 48 Fibers, OS2, Type B

This 48 Fibers (Base-12) MTP® Elite Female trunk assembly is built for backbone cabling between racks, rows and distribution frames. OS2 9/125µm fiber, Plenum (OFNP) jacket and factory installed pulling protection make it a one-pull replacement for hours of field termination work.

Standard lengths are 1m (3ft), 3m (10ft), 5m (16ft), 7m (23ft), 10m (33ft), 15m (49ft), 20m (66ft), 25m (82ft), 30m (98ft) and 40m (131ft). Because we are the manufacturer, any other length between or beyond these steps can be produced on request, with your choice of jacket color, labeling and packaging.

Product Highlights

• MTP® Elite Female (Non-Pinned) to LC Duplex Uniboot, 48 Fibers (Base-12)
• OS2 9/125µm, G.657.A1
• Insertion loss ≤0.35dB, return loss ≥65dB
• Type B polarity
• 8.5-9.0mm Plenum (OFNP) round cable
• Minimum bend radius 10mm
• Ten standard lengths from 1m (3ft) to 40m (131ft), custom lengths built to order

Typical uses include backbone links between the main distribution area and equipment rows, vertical risers between floors, and inter-cabinet trunks in large data halls. The 48 Fibers (Base-12) construction concentrates the equivalent of many duplex jumpers into a single assembly, which is exactly what high density spine and leaf cabling needs. Pre-termination cuts installation time dramatically compared with field splicing.

Inside the outer jacket, the fibers are grouped into sub-units that fan out to individually labeled connectors. This protects the fibers during pulling and keeps the breakout area compact at the panel. Type A, B and C polarity and male or female connectors are built to your panel schedule.

To order, quote HD-48FMTPLCSMF together with the length and quantity you need. The 1m (3ft) version is the standard model; Private labeling, custom packaging and project specific documentation are all handled in-house.

Our engineering team handles custom MPO/MTP assemblies daily. If the standard configuration does not match your link design, send us the requirement and we will build exactly what your network needs at factory-direct cost.

Our test routine covers insertion loss, return loss and ferrule end face inspection on every assembly. Because testing is done in-house, custom variants receive exactly the same verification as standard models.

Each assembly is coiled, capped and sealed in an individual bag, then packed into foam lined export cartons. Test reports can be attached per unit or per batch, and carton marks follow your shipping instructions.