LC UPC to LC UPC Duplex Flat Clip Uniboot OM4, 2.0mm, lszh Fiber Patch Cable

For project teams, the key is to match this exact configuration to the port schedule, optical budget and delivery documentation. This OM4 fiber patch cable carries a LC UPC interface on one end and a LC UPC interface on the other, factory terminated on OM4 glass and optically tested as an entire unit. The uniboot build places the two fibers of the duplex connection inside a single round 2.0mm cord with one combined connector housing, halving this cable count in high-density panels and simplifying polarity management.

Product Highlights

• Uniboot Allows One Cable to Carry Two Fibers to Reduce Cable Congestion in High-Density Patch Fields
• Bend Insensitive Fiber with 7.5mm Min. Bend Radius
• Flat Clip Design Provides Additional Space Between Connectors and Improves Airflow
• Reverse Polarity without Exposing the Fibers or Needing Any Tools
• Termination Is Tested to Ensure Network Performance

OM4 raises the effective modal bandwidth to 4700 MHz·km at 850nm, and that headroom translates directly into reach for the higher-speed interfaces. The price difference against OM3 has largely disappeared, so new cabling plants standardize on OM4 and keep OM3 only for matching installed installations.

A duplex jumper is two fibers with a defined A-to-B crossover. Getting polarity right at the cord level keeps the link consistent end to end, which is why these assemblies are built and tested as a pair rather than as two separate strands.

The uniboot design merges the duplex pair into a single round cord and a single connector housing. In a 400G row where each QSFP-DD port consumes a duplex connection, halving the cord count visibly changes the airflow and the manageability of the patching field.

Standard length options cover the common patching routes: 1m (3ft), 3m (10ft), with custom length offered beyond the list. Specifying the measured path length keeps the slack out of the manager and the strain off these connectors.

Each assembly is terminated with precision zirconia ferrule connectors and optically tested before packing: insertion loss and return loss are verified on every cable, and end-face geometry is inspected for consistent physical contact. This cable ships with dust caps on the two connectors and the test result offered on specify.

Refer to this setup by connector pair, fiber mode and length when ordering a quotation. For configurations outside the listed options, mixed connector families, jackets, identification or project packing, send the need with the inquiry and the factory will verify the build prior to production. Our project support can review the requirement with Shenzhen production before a formal quotation is issued.