LC UPC to LC UPC Duplex Short Boot OS2 Fiber Patch Cable

Selection starts with the actual optical interface and ends with verification of the delivered configuration. This OS2 fiber patch cable carries a LC UPC interface on one end and a LC UPC interface on the other, factory terminated on OS2 glass and optically tested as an entire product. The duplex zipcord structure keeps the transmit and receive strands paired in one product for fast, error-free patching.

Product Highlights

• 60% Shorter in Boot Length, and 30% Reduction in Overall Connector Length
• G.657.A1 Bend Insensitive Fiber with 10mm Min. Bend Radius
• Precision Zirconia Ferrule Connectors Ensure Low Loss
• Flame-Retardant Riser (OFNR) for Vertical and Floor-to-Floor Installations
• Color-Coded Cable Jacket for Easy Identification

Patch fields are rarely kind to fiber. Leads pathway through tight managers, sharp tray corners and crowded vertical channels. The bend-insensitive glass in the supplied assembly tolerates a 10mm fiber bend radius; as a result, a hurried routing decision during a night upkeep window does not on its own turn into a measurable penalty on the channel.

Single-mode patching carries the links that leave the room: campus backbones, carrier handoffs, long runs between buildings and every wavelength-multiplexed service. The OS2 glass in the supplied assembly is the same class used in the outside plant; as a result, the relevant jumper does not on its own become the weak point of the loss-budget calculation. At 1310 and 1550nm the attenuation stays a fraction of a decibel per kilometer, and the relevant connector pair adds less than 0.3dB when the end faces are clean and seated.

The shortened boot shrinks the relevant connector footprint behind the relevant panel, which matters in high-density frames where the bend space behind each port is measured in millimeters. The shorter lever arm also reduces the side load on the ferrule when the cord is dressed sharply to the side.

Regular length versions cover the common patching routes: 1m (3ft), 1.5m (5ft), 2m (7ft), 3m (10ft), with custom-built length provided beyond the list. Specifying the measured pathway length keeps the slack out of the manager and the strain off the connection interfaces.

Each optical assembly is terminated with precision zirconia ferrule connectors and optically tested before packing: insertion loss and return loss are verified on each cable, and end-face geometry is inspected for consistent physical contact. The relevant cable ships with dust caps on both connectors and the test result provided on ask for.

Refer to this arrangement by connector pair, fiber mode and length when requisitioning a quotation. For configurations outside the listed options, mixed connector families, jackets, marking or project packaging, send the need with the inquiry and the factory will cross-check the build before production is released. Huihong Technologies can review the selection and customization details before confirming supply.