Cisco QSFP-4 x 10G-AOC5M Compatible 40G QSFP+ to 4 x 10G SFP+ Active Optical Breakout Cable, 5m (16ft)

This 5m (16ft) AOC cable is built for Cisco equipment requiring the QSFP-4 x 10G-AOC5M interface. The 40Gbps link uses QSFP+ to 4 SFP+ and is supplied as one complete tested assembly.

OEM Part Number: QSFP-4 x 10G-AOC5MHT Part Number: QSFP-4 x 10G-AOC5M

Product Highlights

• Compatible alternative to Cisco QSFP-4 x 10G-AOC5M
• 40G connectivity at 40Gbps
• Interface configuration: QSFP+ to 4 SFP+
• Fixed length and part number: 5m (16ft), QSFP-4 x 10G-AOC5M
• Minimum bend radius: 30mm

This assembly uses OFNP jacket, minimum bend radius 30mm. These mechanical characteristics affect how the cable should be dressed behind the equipment. Avoid sharp edges, excessive ties and repeated tight bends close to the connector boots.

The QSFP+ to 4 SFP+ configuration divides the high-speed interface into multiple lower-speed connections. Verify the upstream lane assignment, downstream port speeds and breakout setting on the host before connecting the assembly. Each branch must attach to the correct remote interface.

The optical engines and fiber are permanently integrated into this AOC. There are no detachable optical modules to clean or exchange. Handle the complete assembly by its connector housings and cable, and keep both ends matched to the same interface specification.

The 5m (16ft) length gives QSFP-4 x 10G-AOC5M more freedom for adjacent-rack and row-end deployments. The integrated optical assembly should be supported along its route without tight bends or connector pull loads; the AOC specification and host support must still match the intended link.

QSFP-4 x 10G-AOC5M occupies the middle of this family between QSFP-4 x 10G-AOC3M at 3m (10ft) and QSFP-4 x 10G-AOC7M at 7m (23ft). It adds 2m over the shorter option for extra routing clearance, while the next longer version adds another 2m. Measure the managed path and choose this version when its reach is sufficient without creating the slack associated with the longer assembly.

The intended application is determined by the host interface and protocol support. Listed interface and protocol references include 10G/40Gigabit Ethernet or Fibre Channel. Confirm that the host firmware and port configuration support the same operating mode.

The HT cable carries the compatibility configuration associated with QSFP-4 x 10G-AOC5M, while its mechanical assembly remains the fixed 5m (16ft) version described here. Incoming inspection, connector examination and a live link test are completed before packing. Customers with unusually old or new Cisco software can request a pre-order check.

Quote HT part number QSFP-4 x 10G-AOC5M with the required quantity. The 5m (16ft) length is fixed for this part number; if a different length is needed, select its corresponding page and OEM reference from the length list above. Standard HT labels and project-specific packaging are available.

Quality control includes connector appearance, cable identification and functional verification. Packing materials are selected to keep the connector housings and cable boots from taking impact during transport, and the coil is not compressed into an undersized bundle. Volume orders can include customer-specific labels and packing documentation.

Lead time for ordinary configurations is normally one to three working days, while production quantities are confirmed with the order. We can arrange express courier or economy freight according to destination and carton volume, or hand the shipment to your appointed logistics provider.