Cisco QSFP-H40G-ACU7M Compatible 40G QSFP+ Active Copper Cable, 7m(23ft)

For short, high-density connections, this ACC cable combines 40G performance with a fixed 7m(23ft) cable run. It corresponds to Cisco QSFP-H40G-ACU7M and uses an actively conditioned copper link for the stated high-speed interface.

OEM Part Number: QSFP-H40G-ACU7MHT Part Number: QSFP-H40G-ACU7M

Product Highlights

• Compatible alternative to Cisco QSFP-H40G-ACU7M
• 40G connectivity at 40Gbps
• Interface configuration: QSFP+ to QSFP+
• Fixed length and part number: 7m(23ft), QSFP-H40G-ACU7M
• Conductor specification: 26AWG
• Minimum bend radius: 37.5mm

This assembly uses 26AWG conductors, PVC (OFNR) jacket, minimum bend radius 37.5mm. These mechanical characteristics affect how the cable should be dressed behind the equipment. Avoid sharp edges, excessive ties and repeated tight bends close to the connector boots.

The extended 7m(23ft) reach supports connections across adjacent racks or between separated equipment rows. Secure the cable along its route, protect both ends from pull loads and preserve ventilation. The integrated ACC construction avoids a chain of separate modules and patch leads.

QSFP-H40G-ACU7M is the shortest of 2 verified length options in this family. It is the preferred choice when the port positions are close and cable slack must be kept to a minimum. The next option is QSFP-H40G-ACU10M at 10m (33ft), adding 3m for a less direct routing path; selecting it unnecessarily would leave more cable to dress.

The intended application is determined by the host interface and protocol support. Listed interface and protocol references include 40G InfiniBand 8x DDR, 4x QDR, 10G/40Gigabit Ethernet, Fibre Channel. Confirm that the host firmware and port configuration support the same operating mode.

The assembly is configured for equipment that recognizes QSFP-H40G-ACU7M. Before shipment, we inspect both connectors and verify identification, link establishment and electrical continuity, link stability and diagnostic readouts. Host hardware and firmware revisions can affect third-party cable acceptance, so customers can provide the equipment model and software release for a pre-order compatibility review.

Quote HT part number QSFP-H40G-ACU7M with the required quantity. The 7m(23ft) length is fixed for this part number; if a different length is needed, select its corresponding page and OEM reference from the length list above. Standard HT labels and project-specific packaging are available.

Before packing, our team checks the cable jacket, connector boots, latches and identification of each assembly. The cable is then secured in a loose coil and protected against dust and connector impact. Neutral packaging, customer part-number labels and project-specific carton lists can be supplied on request.

Lead time for ordinary configurations is normally one to three working days, while production quantities are confirmed with the order. We can arrange express courier or economy freight according to destination and carton volume, or hand the shipment to your appointed logistics provider.