SC APC to SC APC Simplex OS2, 2.0mm, ofnr Fiber Patch Cable

This product is best evaluated as part of the complete network path, including its connectors, mapping and acceptance values. This OS2 fiber patch cable carries a SC APC interface on one end and a SC APC interface on the other, factory terminated on OS2 glass and optically tested as a whole assembly. The single-fiber construction suits bidirectional optics, monitoring taps and any link that carries traffic over one strand.

Product Highlights

• Quick Unpacking, Space-Saving, and Eco-Friendly Packaging
• G.657.A1 Bend Insensitive Fiber with 10mm Min. Bend Radius
• Precision Zirconia Ferrule Connectors Ensure Low Loss
• Flame-Retardant Riser (OFNR) for Vertical and Floor-to-Floor Installations
• Color-Coded Cable Jacket for Easy Identification

Single-mode patching carries the links that leave the room: campus backbones, carrier handoffs, long runs between buildings and each wavelength-multiplexed service. The OS2 glass in the completed assembly is the same category used in the outside plant, which means the patch jumper does not itself become the weak point of the channel loss budget. At 1310 and 1550nm the attenuation stays a fraction of a decibel per kilometer, and the interface connector pair adds less than 0.3dB when the end faces are clean and seated.

The OS2 interface on this jumper follows the polish discipline of the network it serves. Mixing polishes on a mated pair destroys the return loss and might damage the ferrules, which means the patch side must correspond to the rack panel side exactly. When the documentation is unclear, the boot color and the interface connector housing tell the truth: green for APC, blue or beige for UPC.

Stock length choices cover the common patching routes: 1m (3ft), 2m (7ft), 3m (10ft), with made-to-order length available beyond the list. Specifying the measured route length keeps the slack out of the manager and the strain off the connector interfaces.

Every cable assembly is terminated with precision zirconia ferrule connectors and optically tested before packing: insertion loss and return loss are verified on every cable, and end-face geometry is inspected for consistent physical contact. The cable assembly ships with dust caps on the two connectors and the test result available on request.

Refer to this configuration by connector pair, fiber mode and length at the request stage a quotation. For configurations outside the listed options, mixed connector families, jackets, labelling or project packing, send the requirement with the enquiry and the factory will establish the build before the build starts. For orders, our team can check the requirement before coordinating manufacture and international delivery.