Cisco SFP-H10GB-CU1-5M Compatible 10G SFP+ Passive Copper Twinax Cable, 1.5m (5ft)

This 1.5m (5ft) DAC cable is built for Cisco equipment requiring the SFP-H10GB-CU1-5M interface. The 10Gbps link uses SFP+ to SFP+ and is supplied as one complete tested assembly.

OEM Part Number: SFP-H10GB-CU1-5MHT Part Number: SFP-H10GB-CU1-5M

Product Highlights

• Compatible alternative to Cisco SFP-H10GB-CU1-5M
• 10G connectivity at 10Gbps
• Interface configuration: SFP+ to SFP+
• Fixed length and part number: 1.5m (5ft), SFP-H10GB-CU1-5M
• Cable construction: Passive Twinax
• Conductor specification: 30AWG
• Maximum power consumption: ≤0.1W
• Minimum bend radius: 23mm

The rated power consumption is ≤0.1W. Include this load in the host-port power and thermal budget, especially in densely populated switches. Maintain front-panel clearance and do not bundle the cable so tightly that it obstructs airflow around the connectors.

The additional half metre beyond a one-metre assembly gives SFP-H10GB-CU1-5M useful routing flexibility when the ports are not directly aligned. It can accommodate a different rack unit or a short service loop, but excess cable should be dressed loosely rather than folded into a tight coil.

SFP-H10GB-CU1-5M occupies the middle of this family between SFP-H10GB-CU1M at 1m (3ft) and SFP-H10GB-CU2M at 2m (7ft). It adds 0.5m over the shorter option for extra routing clearance, while the next longer version adds another 0.5m. Measure the managed path and choose this version when its reach is sufficient without creating the slack associated with the longer assembly.

This assembly uses 30AWG conductors, PVC (OFNR) jacket, minimum bend radius 23mm. These mechanical characteristics affect how the cable should be dressed behind the equipment. Avoid sharp edges, excessive ties and repeated tight bends close to the connector boots.

The intended application is 10G Ethernet. Listed interface and protocol references include 1x InfiniBand QDR, DDR, SDR, 10 Gigabit Ethernet, Fibre Channel. Confirm that the host firmware and port configuration support the same operating mode.

A passive DAC has no separate optical conversion stage. Its low-power, low-latency operation is useful for short equipment links, but the assembly must remain within the length and signaling mode accepted by both hosts.

Our compatibility setup for Cisco SFP-H10GB-CU1-5M is checked together with the physical 1.5m (5ft) assembly. Factory verification covers connector condition, host identification, error-free link establishment and electrical continuity, link stability and diagnostic readouts. Providing the exact host model and firmware release helps us identify platform-specific requirements before production.

Use part number SFP-H10GB-CU1-5M for the 1.5m (5ft) assembly. For mixed-length projects, list each required part number and quantity separately so that every cable can be tested and packed according to its intended installation.

HT inspects and tests every completed cable before it enters finished stock. Protective caps or covers are fitted where applicable, followed by anti-static or tray packaging and an outer carton. Custom labels can cross-reference the customer part number, SFP-H10GB-CU1-5M and the 1.5m (5ft) length for easier inventory control.

Standard configurations normally ship within one to three working days. Worldwide courier, air freight and sea freight options are available, and shipments can also be sent on your own courier account or delivered to an appointed forwarder.