SFP+ to SFP+-10G-AOC-1M3FT 10G SFP+ Industrial Active Optical Cable, 1m (3ft)

For short, high-density connections, this AOC cable combines 10G performance with a fixed 1m (3ft) cable run. It corresponds to Generic SFP+ to SFP+-10G-AOC-1M3FT and uses a factory-terminated active optical link with the optical engines and fiber integrated into the assembly.

OEM Part Number: SFP+ to SFP+-10G-AOC-1M3FTHT Part Number: SFP+ to SFP+-10G-AOC-1M3FT

Product Highlights

• HT-manufactured AOC assembly in 1m (3ft)
• Interface configuration: SFP+ to SFP+
• Fixed length and part number: 1m (3ft), SFP+ to SFP+-10G-AOC-1M3FT
• Minimum bend radius: 30mm

This assembly uses OFNP jacket, minimum bend radius 30mm. These mechanical characteristics affect how the cable should be dressed behind the equipment. Avoid sharp edges, excessive ties and repeated tight bends close to the connector boots.

At 1m (3ft), SFP+ to SFP+-10G-AOC-1M3FT is a practical choice for direct connections within one rack. Route the cable along the intended management path rather than pulling it diagonally across adjacent connectors, and leave enough clearance for insertion, removal and front-panel airflow.

SFP+ to SFP+-10G-AOC-1M3FT is the shortest of 3 verified length options in this family. It is the preferred choice when the port positions are close and cable slack must be kept to a minimum. The next option is SFP+ to SFP+-10G-AOC-50M164FT at 50m (164ft), adding 49m for a less direct routing path; selecting it unnecessarily would leave more cable to dress.

The intended application is determined by the host interface and protocol support. Listed interface and protocol references include SFF-8431,10GBASE Ethernet, Fibre Channel. Confirm that the host firmware and port configuration support the same operating mode.

The optical engines and fiber are permanently integrated into this AOC. There are no detachable optical modules to clean or exchange. Handle the complete assembly by its connector housings and cable, and keep both ends matched to the same interface specification.

For this Generic application, testing combines digital identification with actual traffic-link verification and optical link operation, receive activity and diagnostic readouts. Both ends are inspected for latch, boot and connector damage. If the project uses a specific hardware revision or a channelized port, send those details so that the intended configuration can be reviewed before shipment.

Use part number SFP+ to SFP+-10G-AOC-1M3FT for the 1m (3ft) assembly. For mixed-length projects, list each required part number and quantity separately so that every cable can be tested and packed according to its intended installation.

Production inspection covers both physical condition and a live link check. Connector ends receive individual protection, and the completed assembly is packed without tight ties or sharp bends. For multi-length projects, cartons can be separated and labelled by OEM part number to simplify installation on site.

Lead time for ordinary configurations is normally one to three working days, while production quantities are confirmed with the order. We can arrange express courier or economy freight according to destination and carton volume, or hand the shipment to your appointed logistics provider.