SFP+ to SFP+-10G-AOC-25M82FT 10G SFP+ Active Optical Cable, 25m (82ft)

Use the SFP+ to SFP+-10G-AOC-25M82FT compatible assembly where a 10G connection is required between compatible ports. This page covers the 25m (82ft) version only, with its own HT part number, specifications and compatibility verification.

OEM Part Number: SFP+ to SFP+-10G-AOC-25M82FTHT Part Number: SFP+ to SFP+-10G-AOC-25M82FT

Product Highlights

• HT-manufactured AOC assembly in 25m (82ft)
• 10G connectivity at 10Gbps
• Interface configuration: SFP+ to SFP+
• Fixed length and part number: 25m (82ft), SFP+ to SFP+-10G-AOC-25M82FT
• Cable construction: OM3
• Maximum power consumption: <0.8W
• Minimum bend radius: 30mm

The rated power consumption is <0.8W. Include this load in the host-port power and thermal budget, especially in densely populated switches. Maintain front-panel clearance and do not bundle the cable so tightly that it obstructs airflow around the connectors.

The intended application is determined by the host interface and protocol support. Listed interface and protocol references include SFF-8636, 1xInfiniBand QDR,DDR,SDR, 10G Gigabit Ethernet. Confirm that the host firmware and port configuration support the same operating mode.

The optical engines and fiber are permanently integrated into this AOC. There are no detachable optical modules to clean or exchange. Handle the complete assembly by its connector housings and cable, and keep both ends matched to the same interface specification.

The extended 25m (82ft) reach supports connections across adjacent racks or between separated equipment rows. Secure the cable along its route, protect both ends from pull loads and preserve ventilation. The integrated AOC construction avoids a chain of separate modules and patch leads.

SFP+ to SFP+-10G-AOC-25M82FT occupies the middle of this family between SFP+ to SFP+-10G-AOC-20M66FT at 20m (66ft) and SFP+ to SFP+-10G-AOC-30M98FT at 30m (98ft). It adds 5m over the shorter option for extra routing clearance, while the next longer version adds another 5m. Measure the managed path and choose this version when its reach is sufficient without creating the slack associated with the longer assembly.

This assembly uses OFNP jacket, minimum bend radius 30mm. These mechanical characteristics affect how the cable should be dressed behind the equipment. Avoid sharp edges, excessive ties and repeated tight bends close to the connector boots.

The HT cable carries the compatibility configuration associated with SFP+ to SFP+-10G-AOC-25M82FT, while its mechanical assembly remains the fixed 25m (82ft) version described here. Incoming inspection, connector examination and a live link test are completed before packing. Customers with unusually old or new Generic software can request a pre-order check.

Use part number SFP+ to SFP+-10G-AOC-25M82FT for the 25m (82ft) assembly. For mixed-length projects, list each required part number and quantity separately so that every cable can be tested and packed according to its intended installation.

Production inspection covers both physical condition and a live link check. Connector ends receive individual protection, and the completed assembly is packed without tight ties or sharp bends. For multi-length projects, cartons can be separated and labelled by OEM part number to simplify installation on site.

Lead time for ordinary configurations is normally one to three working days, while production quantities are confirmed with the order. We can arrange express courier or economy freight according to destination and carton volume, or hand the shipment to your appointed logistics provider.