SFP to SFP-High-Speed-DAC-1M3FT 1G SFP Passive Copper Twinax Cable, 1m (3ft)

For short, high-density connections, this DAC cable combines High-Speed performance with a fixed 1m (3ft) cable run. It corresponds to Generic SFP to SFP-High-Speed-DAC-1M3FT and uses a factory-terminated passive copper link without separate optical modules or patch cords.

OEM Part Number: SFP to SFP-High-Speed-DAC-1M3FTHT Part Number: SFP to SFP-High-Speed-DAC-1M3FT

Product Highlights

• HT-manufactured DAC assembly in 1m (3ft)
• High-Speed connectivity at 1Gbps
• Interface configuration: SFP to SFP
• Fixed length and part number: 1m (3ft), SFP to SFP-High-Speed-DAC-1M3FT
• Cable construction: Passive Twinax
• Conductor specification: 30AWG
• Maximum power consumption: ≤0.1W
• Minimum bend radius: 23mm

The rated power consumption is ≤0.1W. Include this load in the host-port power and thermal budget, especially in densely populated switches. Maintain front-panel clearance and do not bundle the cable so tightly that it obstructs airflow around the connectors.

A passive DAC has no separate optical conversion stage. Its low-power, low-latency operation is useful for short equipment links, but the assembly must remain within the length and signaling mode accepted by both hosts.

At 1m (3ft), SFP to SFP-High-Speed-DAC-1M3FT is a practical choice for direct connections within one rack. Route the cable along the intended management path rather than pulling it diagonally across adjacent connectors, and leave enough clearance for insertion, removal and front-panel airflow.

SFP to SFP-High-Speed-DAC-1M3FT occupies the middle of this family between SFP to SFP-High-Speed-DAC-0.5M2FT at 0.5m (2ft) and SFP to SFP-High-Speed-DAC-2M7FT at 2m (7ft). It adds 0.5m over the shorter option for extra routing clearance, while the next longer version adds another 1m. Measure the managed path and choose this version when its reach is sufficient without creating the slack associated with the longer assembly.

This assembly uses 30AWG conductors, PVC (OFNR) jacket, minimum bend radius 23mm. These mechanical characteristics affect how the cable should be dressed behind the equipment. Avoid sharp edges, excessive ties and repeated tight bends close to the connector boots.

The intended application is determined by the host interface and protocol support. Listed interface and protocol references include 1G Ethernet. Confirm that the host firmware and port configuration support the same operating mode.

The assembly is configured for equipment that recognizes SFP to SFP-High-Speed-DAC-1M3FT. Before shipment, we inspect both connectors and verify identification, link establishment and electrical continuity, link stability and diagnostic readouts. Host hardware and firmware revisions can affect third-party cable acceptance, so customers can provide the equipment model and software release for a pre-order compatibility review.

Use part number SFP to SFP-High-Speed-DAC-1M3FT for the 1m (3ft) assembly. For mixed-length projects, list each required part number and quantity separately so that every cable can be tested and packed according to its intended installation.

Before packing, our team checks the cable jacket, connector boots, latches and identification of each assembly. The cable is then secured in a loose coil and protected against dust and connector impact. Neutral packaging, customer part-number labels and project-specific carton lists can be supplied on request.

Lead time for ordinary configurations is normally one to three working days, while production quantities are confirmed with the order. We can arrange express courier or economy freight according to destination and carton volume, or hand the shipment to your appointed logistics provider.