MTP-12 to MTP-12 UPC Jumper, 12 Fibers, OM4, Type A

Our MTP® Elite Female jumper uses OM4 50/125µm fiber and Plenum (OFNP) jacket to deliver a clean, repeatable connection between patch panels, cassettes and active equipment. 12 Fibers in one compact round cable keeps cable management simple even in dense installations.

Available lengths are 5m (16ft), 10m (33ft), 15m (49ft), 20m (66ft), 25m (82ft) and 30m (98ft). We can also produce any intermediate or longer length to order, with your choice of labeling and packaging.

Product Highlights

• MTP® Elite Female (Non-Pinned) to MTP® Elite Female (Non-Pinned), 12 Fibers
• OM4 50/125µm, bend insensitive fiber
• Insertion loss ≤0.35dB (0.15dB Typ.), return loss ≥27dB
• Type A polarity (straight through)
• 3.0mm Plenum (OFNP) round cable
• Minimum bend radius 7.5mm
• Stock lengths from 5m (16ft) to 30m (98ft), custom lengths on request

Use this jumper anywhere a short multi-fiber connection is needed: panel to equipment, cassette to cassette, or switch to switch within a row. A 12-fiber MPO interface carries 8 active lanes for 40G SR4 and 100G SR4 links, leaving the remaining 4 fibers dark, exactly as the MSA wiring specifies. Because it arrives polished and tested, the installer only needs to route and connect it.

The same jumper can be produced with different polarity and gender combinations. Male connectors carry guide pins for direct module connection, while female versions are used at panels. Polarity A, B and C are all standard for us, and our engineers can check your link diagram if you are unsure which one to order.

Ordering is simple: send us 12FMTPOM4 and your required lengths and quantities, and we return a factory quote the same working day. Small trial orders are welcome before you commit to a full project rollout.

As a factory we can modify almost every detail of this product: length, jacket material and color, polarity, gender, breakout geometry, labeling and packaging. Non-standard variants are routine work for us, not a special project.

Every MPO/MTP assembly leaving our factory is 100% tested for insertion loss and return loss, with end face geometry checks on the multi-fiber ferrules. Controlled polishing keeps the loss budget stable across the whole batch, which matters when several mated pairs sit in one link.

Each assembly is coiled, capped and sealed in an individual bag, then packed into foam lined export cartons. Test reports can be attached per unit or per batch, and carton marks follow your shipping instructions.