Juniper Networks JNP-25G-AOC-4M Compatible 25G SFP28 Active Optical Cable, 4m (13ft)

With a fixed 4m (13ft) cable and SFP28 to SFP28, the JNP-25G-AOC-4M compatible assembly simplifies 25G deployment. It is manufactured and tested by HT for Juniper Networks equipment.

OEM Part Number: JNP-25G-AOC-4MHT Part Number: JNP-25G-AOC-4M

Product Highlights

• Compatible alternative to Juniper Networks JNP-25G-AOC-4M
• 25G connectivity at 25Gbps
• Interface configuration: SFP28 to SFP28
• Fixed length and part number: 4m (13ft), JNP-25G-AOC-4M
• Minimum bend radius: 30mm

Juniper platform documentation distinguishes straight QSFP28 DAC or AOC connections from DACBO and AOCBO breakout operation. On channelized systems, the host port must be configured for the required breakout mode. Match this HT compatible cable to the exact Juniper part number and the intended platform configuration.

JNP-25G-AOC-4M occupies the middle of this family between JNP-25G-AOC-3M at 3m (10ft) and JNP-25G-AOC-5M at 5m (16ft). It adds 1m over the shorter option for extra routing clearance, while the next longer version adds another 1m. Measure the managed path and choose this version when its reach is sufficient without creating the slack associated with the longer assembly.

This assembly uses OFNP jacket, minimum bend radius 30mm. These mechanical characteristics affect how the cable should be dressed behind the equipment. Avoid sharp edges, excessive ties and repeated tight bends close to the connector boots.

The optical engines and fiber are permanently integrated into this AOC. There are no detachable optical modules to clean or exchange. Handle the complete assembly by its connector housings and cable, and keep both ends matched to the same interface specification.

The 4m (13ft) length gives JNP-25G-AOC-4M more freedom for adjacent-rack and row-end deployments. The integrated optical assembly should be supported along its route without tight bends or connector pull loads; the AOC specification and host support must still match the intended link.

The assembly is configured for equipment that recognizes JNP-25G-AOC-4M. Before shipment, we inspect both connectors and verify identification, link establishment and optical link operation, receive activity and diagnostic readouts. Host hardware and firmware revisions can affect third-party cable acceptance, so customers can provide the equipment model and software release for a pre-order compatibility review.

Use part number JNP-25G-AOC-4M for the 4m (13ft) assembly. For mixed-length projects, list each required part number and quantity separately so that every cable can be tested and packed according to its intended installation.

Before packing, our team checks the cable jacket, connector boots, latches and identification of each assembly. The cable is then secured in a loose coil and protected against dust and connector impact. Neutral packaging, customer part-number labels and project-specific carton lists can be supplied on request.

Standard configurations normally ship within one to three working days. Worldwide courier, air freight and sea freight options are available, and shipments can also be sent on your own courier account or delivered to an appointed forwarder.