LC UPC to LC UPC Duplex Standard Clip Uniboot OM3 Fiber Patch Cable

High-density designs should assess this item together with panel access, cable routing and the complete optical loss allowance. This OM3 fiber patch cable carries a LC UPC interface on one end and a LC UPC interface on the other, factory terminated on OM3 glass and optically tested as a full product. The uniboot structure places both fibers of the duplex channel inside a single round 2.0mm cord with one combined connector housing, halving this optical cable count in high-density panels and simplifying polarity management.

Product Highlights

• Uniboot Allows One Cable to Carry Two Fibers to Reduce Cable Congestion in High-Density Patch Fields
• Bend Insensitive Fiber with 7.5mm Min. Bend Radius
• Termination Is Tested to Ensure Network Performance
• Designed for High-Density Fiber Cabling in Network Cabinet Connections, Ceiling Wiring and Under-Floor Wiring in a Data Center
• Support for Various Transmission Speed Ethernet Applications

Multimode links fail more commonly from contamination than from fiber damage. Every ferrule should be inspected and cleaned before connector engagement, and the dust caps should stay on until the moment of link. These habits matter more than any specification on the datasheet.

This OM3 product matches the existing base of OM3 path cabling: 10G links to 300 meters and 40/100G SR4 links to 70 meters. When the permanent channel is OM3, patching with OM3 keeps the path specification homogeneous and the test reports clean.

Uniboot connectors expose the polarity through the housing rather than the termination: the latches or clips let the installer swap the fiber positions without opening the cord. A polarity mistake discovered at turn-up becomes a two-minute correction instead of a replacement order. This check should form part of the rack-access and acceptance review.

Standard cable lengths cover the common patching routes: 1m (3ft), 2m (7ft), 3m (10ft), 5m (16ft), with custom length obtainable beyond the list. Specifying the measured pathway length keeps the slack out of the manager and the strain off these optical interfaces.

Each completed assembly is terminated with precision zirconia ferrule connectors and optically tested before packing: insertion loss and return loss are verified on each cable, and end-face geometry is inspected for consistent physical contact. This optical cable ships with dust caps on both connectors and the test result obtainable on ask for.

Refer to this arrangement by connector pair, fiber mode and length during the request for a quotation. For configurations outside the listed options, mixed connector families, jackets, marking or project packaging, send the requirement with the enquiry and the factory will review the build before manufacturing begins. Project orders can be reviewed for interface compatibility, packing details and delivery coordination.