SFP28 to SFP28-25G-AOC-4M13FT 25G SFP28 Active Optical Cable, 4m (13ft)

This 4m (13ft) AOC cable is built for multi-vendor equipment requiring the SFP28 to SFP28-25G-AOC-4M13FT interface. The 25Gbps link uses SFP28 to SFP28 and is supplied as one complete tested assembly.

OEM Part Number: SFP28 to SFP28-25G-AOC-4M13FTHT Part Number: SFP28 to SFP28-25G-AOC-4M13FT

Product Highlights

• HT-manufactured AOC assembly in 4m (13ft)
• 25G connectivity at 25Gbps
• Interface configuration: SFP28 to SFP28
• Fixed length and part number: 4m (13ft), SFP28 to SFP28-25G-AOC-4M13FT
• Minimum bend radius: 30mm

This assembly uses OFNP jacket, minimum bend radius 30mm. These mechanical characteristics affect how the cable should be dressed behind the equipment. Avoid sharp edges, excessive ties and repeated tight bends close to the connector boots.

The optical engines and fiber are permanently integrated into this AOC. There are no detachable optical modules to clean or exchange. Handle the complete assembly by its connector housings and cable, and keep both ends matched to the same interface specification.

The 4m (13ft) length gives SFP28 to SFP28-25G-AOC-4M13FT more freedom for adjacent-rack and row-end deployments. The integrated optical assembly should be supported along its route without tight bends or connector pull loads; the AOC specification and host support must still match the intended link.

SFP28 to SFP28-25G-AOC-4M13FT occupies the middle of this family between SFP28 to SFP28-25G-AOC-3M10FT at 3m (10ft) and SFP28 to SFP28-25G-AOC-5M16FT at 5m (16ft). It adds 1m over the shorter option for extra routing clearance, while the next longer version adds another 1m. Measure the managed path and choose this version when its reach is sufficient without creating the slack associated with the longer assembly.

Our compatibility setup for Generic SFP28 to SFP28-25G-AOC-4M13FT is checked together with the physical 4m (13ft) assembly. Factory verification covers connector condition, host identification, error-free link establishment and optical link operation, receive activity and diagnostic readouts. Providing the exact host model and firmware release helps us identify platform-specific requirements before production.

This product is ordered as SFP28 to SFP28-25G-AOC-4M13FT in 4m (13ft). Include the equipment model and software release if you would like a pre-order compatibility review. Other lengths use different part numbers and should not be substituted into the same order line.

Production inspection covers both physical condition and a live link check. Connector ends receive individual protection, and the completed assembly is packed without tight ties or sharp bends. For multi-length projects, cartons can be separated and labelled by OEM part number to simplify installation on site.

Lead time for ordinary configurations is normally one to three working days, while production quantities are confirmed with the order. We can arrange express courier or economy freight according to destination and carton volume, or hand the shipment to your appointed logistics provider.