SFP28 to SFP28-25G-DAC-3M10FT 25G SFP28 Passive Copper Twinax Cable, 3m (10ft)

This HT cable matches the SFP28 to SFP28-25G-DAC-3M10FT requirement for multi-vendor equipment. The 3m (10ft) assembly supports 25G operation and provides a factory-terminated passive copper link without separate optical modules or patch cords; its complete electrical and mechanical details are listed below.

OEM Part Number: SFP28 to SFP28-25G-DAC-3M10FTHT Part Number: SFP28 to SFP28-25G-DAC-3M10FT

Product Highlights

• HT-manufactured DAC assembly in 3m (10ft)
• 25G connectivity at 25Gbps
• Interface configuration: SFP28 to SFP28
• Fixed length and part number: 3m (10ft), SFP28 to SFP28-25G-DAC-3M10FT
• Conductor specification: 30AWG
• Minimum bend radius: 21.25mm

This assembly uses 30AWG conductors, PVC (OFNR) jacket, minimum bend radius 21.25mm. These mechanical characteristics affect how the cable should be dressed behind the equipment. Avoid sharp edges, excessive ties and repeated tight bends close to the connector boots.

At 3m (10ft), this assembly can bridge non-aligned ports or adjacent racks while remaining a single direct-attach link. Support longer horizontal runs with suitable cable management and preserve space for cooling and future maintenance.

SFP28 to SFP28-25G-DAC-3M10FT occupies the middle of this family between SFP28 to SFP28-25G-DAC-2.5M8FT at 2.5m (8ft) and SFP28 to SFP28-25G-DAC-4M13FT at 4m (13ft). It adds 0.5m over the shorter option for extra routing clearance, while the next longer version adds another 1m. Measure the managed path and choose this version when its reach is sufficient without creating the slack associated with the longer assembly.

The intended application is 25G Ethernet, Data Center, 5G Wireless. Listed interface and protocol references include IEEE 802.3, SFP28 MSA, SFF-8402, Infiniband, EIA 364-1000. Confirm that the host firmware and port configuration support the same operating mode.

A passive DAC has no separate optical conversion stage. Its low-power, low-latency operation is useful for short equipment links, but the assembly must remain within the length and signaling mode accepted by both hosts.

Compatibility is more than matching the SFP28 to SFP28 shape. This assembly is prepared for hosts expecting SFP28 to SFP28-25G-DAC-3M10FT and is checked for identification, stable link behavior and electrical continuity, link stability and diagnostic readouts. We recommend confirming the equipment model and software release for critical deployments or mixed-vendor installations.

This product is ordered as SFP28 to SFP28-25G-DAC-3M10FT in 3m (10ft). Include the equipment model and software release if you would like a pre-order compatibility review. Other lengths use different part numbers and should not be substituted into the same order line.

Before packing, our team checks the cable jacket, connector boots, latches and identification of each assembly. The cable is then secured in a loose coil and protected against dust and connector impact. Neutral packaging, customer part-number labels and project-specific carton lists can be supplied on request.

Lead time for ordinary configurations is normally one to three working days, while production quantities are confirmed with the order. We can arrange express courier or economy freight according to destination and carton volume, or hand the shipment to your appointed logistics provider.