SFP28 to SFP28-25G-DAC-1.5M5FT 25G SFP28 Passive Copper Twinax Cable, 1.5m (5ft)

With a fixed 1.5m (5ft) cable and SFP28 to SFP28, the SFP28 to SFP28-25G-DAC-1.5M5FT compatible assembly simplifies 25G deployment. It is manufactured and tested by HT for multi-vendor equipment.

OEM Part Number: SFP28 to SFP28-25G-DAC-1.5M5FTHT Part Number: SFP28 to SFP28-25G-DAC-1.5M5FT

Product Highlights

• HT-manufactured DAC assembly in 1.5m (5ft)
• 25G connectivity at 25Gbps
• Interface configuration: SFP28 to SFP28
• Fixed length and part number: 1.5m (5ft), SFP28 to SFP28-25G-DAC-1.5M5FT
• Conductor specification: 30AWG
• Minimum bend radius: 21.25mm

This assembly uses 30AWG conductors, PVC (OFNR) jacket, minimum bend radius 21.25mm. These mechanical characteristics affect how the cable should be dressed behind the equipment. Avoid sharp edges, excessive ties and repeated tight bends close to the connector boots.

The additional half metre beyond a one-metre assembly gives SFP28 to SFP28-25G-DAC-1.5M5FT useful routing flexibility when the ports are not directly aligned. It can accommodate a different rack unit or a short service loop, but excess cable should be dressed loosely rather than folded into a tight coil.

SFP28 to SFP28-25G-DAC-1.5M5FT occupies the middle of this family between SFP28 to SFP28-25G-DAC-1M3FT at 1m (3ft) and SFP28 to SFP28-25G-DAC-2M7FT at 2m (7ft). It adds 0.5m over the shorter option for extra routing clearance, while the next longer version adds another 0.5m. Measure the managed path and choose this version when its reach is sufficient without creating the slack associated with the longer assembly.

The intended application is 25G Ethernet, Data Center, 5G Wireless. Listed interface and protocol references include IEEE 802.3, SFP28 MSA, SFF-8402, Infiniband, EIA 364-1000. Confirm that the host firmware and port configuration support the same operating mode.

A passive DAC has no separate optical conversion stage. Its low-power, low-latency operation is useful for short equipment links, but the assembly must remain within the length and signaling mode accepted by both hosts.

Compatibility is more than matching the SFP28 to SFP28 shape. This assembly is prepared for hosts expecting SFP28 to SFP28-25G-DAC-1.5M5FT and is checked for identification, stable link behavior and electrical continuity, link stability and diagnostic readouts. We recommend confirming the equipment model and software release for critical deployments or mixed-vendor installations.

Quote HT part number SFP28 to SFP28-25G-DAC-1.5M5FT with the required quantity. The 1.5m (5ft) length is fixed for this part number; if a different length is needed, select its corresponding page and OEM reference from the length list above. Standard HT labels and project-specific packaging are available.

Production inspection covers both physical condition and a live link check. Connector ends receive individual protection, and the completed assembly is packed without tight ties or sharp bends. For multi-length projects, cartons can be separated and labelled by OEM part number to simplify installation on site.

Standard configurations normally ship within one to three working days. Worldwide courier, air freight and sea freight options are available, and shipments can also be sent on your own courier account or delivered to an appointed forwarder.