SFP28 to SFP28-25G-DAC-1M3FT 25G SFP28 Passive Copper Twinax Cable, 1m (3ft)

With a fixed 1m (3ft) cable and SFP28 to SFP28, the SFP28 to SFP28-25G-DAC-1M3FT compatible assembly simplifies 25G deployment. It is manufactured and tested by HT for multi-vendor equipment.

OEM Part Number: SFP28 to SFP28-25G-DAC-1M3FTHT Part Number: SFP28 to SFP28-25G-DAC-1M3FT

Product Highlights

• HT-manufactured DAC assembly in 1m (3ft)
• 25G connectivity at 25Gbps
• Interface configuration: SFP28 to SFP28
• Fixed length and part number: 1m (3ft), SFP28 to SFP28-25G-DAC-1M3FT
• Conductor specification: 30AWG
• Minimum bend radius: 21.25mm

This assembly uses 30AWG conductors, PVC (OFNR) jacket, minimum bend radius 21.25mm. These mechanical characteristics affect how the cable should be dressed behind the equipment. Avoid sharp edges, excessive ties and repeated tight bends close to the connector boots.

SFP28 to SFP28-25G-DAC-1M3FT is the shortest of 7 verified length options in this family. It is the preferred choice when the port positions are close and cable slack must be kept to a minimum. The next option is SFP28 to SFP28-25G-DAC-1.5M5FT at 1.5m (5ft), adding 0.5m for a less direct routing path; selecting it unnecessarily would leave more cable to dress.

The intended application is 25G Ethernet, Data Center, 5G Wireless. Listed interface and protocol references include IEEE 802.3, SFP28 MSA, SFF-8402, Infiniband, EIA 364-1000. Confirm that the host firmware and port configuration support the same operating mode.

A passive DAC has no separate optical conversion stage. Its low-power, low-latency operation is useful for short equipment links, but the assembly must remain within the length and signaling mode accepted by both hosts.

At 1m (3ft), SFP28 to SFP28-25G-DAC-1M3FT is a practical choice for direct connections within one rack. Route the cable along the intended management path rather than pulling it diagonally across adjacent connectors, and leave enough clearance for insertion, removal and front-panel airflow.

The HT cable carries the compatibility configuration associated with SFP28 to SFP28-25G-DAC-1M3FT, while its mechanical assembly remains the fixed 1m (3ft) version described here. Incoming inspection, connector examination and a live link test are completed before packing. Customers with unusually old or new Generic software can request a pre-order check.

When ordering, specify SFP28 to SFP28-25G-DAC-1M3FT, cable length 1m (3ft) and the host platform. This allows our team to verify both the physical assembly and the compatibility requirement before production. Neutral labeling and customer packing lists can be arranged for volume orders.

Before packing, our team checks the cable jacket, connector boots, latches and identification of each assembly. The cable is then secured in a loose coil and protected against dust and connector impact. Neutral packaging, customer part-number labels and project-specific carton lists can be supplied on request.

Lead time for ordinary configurations is normally one to three working days, while production quantities are confirmed with the order. We can arrange express courier or economy freight according to destination and carton volume, or hand the shipment to your appointed logistics provider.